Rubik's Cube: a solve that staysLesson 9about 13 minutes

Twisting the last corners

The last step uses the first move you learned, run in pairs.

Every piece is in its place now. The only thing left is that some yellow corners are twisted. This lesson fixes them, and after it you can solve the cube from any scramble. You do not need a new algorithm. You need Lesson 4’s opener, a different hold, and the nerve to keep going when the cube looks wrecked.

Thirty seconds, from memory

Rebuild the top-corner algorithm from its parts: A = U R U' and B = L'. Write A B A' B' out in full.

Write it down first, then check

U R U' L' U R' U' L. To undo A, reverse its moves and flip each prime: U R U' becomes U R' U'.

1. Not Sune

You might expect this step to use Sune from Lesson 7. It doesn’t: Sune moves the top corners out of their places, and those places are what you just finished. The standard beginner method uses a different move here, and you already own it.1

2. The hold: flip the cube

Turn the cube over. Yellow down, white up. Then turn the bottom layer with D until a twisted yellow corner sits at the bottom front right. A corner is twisted when its yellow sticker faces the front or the right instead of the floor.

That is the slot you worked in Lesson 4. In Lesson 4 a white corner went into it. Now a yellow corner is already in it, and only needs turning on the spot.

Cube in hand

Flip the cube so yellow is down. Tip it to look underneath and count the corners whose yellow is not on the bottom. You will see 0, 2, 3 or 4. Never exactly 1. Section 5 says why.

3. The move

R U R' U'

Lesson 4’s opener: lift, turn, drop, reset. It is also the commutator [R, U]: do R, do U, undo R, undo U.2 Its effect on the yellow layer is small and exact. Measured on the simulator’s cube model, one run changes only the bottom-front-right corner. The other three yellow corners and all four yellow edges stay where they are.

Always run it in pairs. After an odd number of runs, a white corner sits in the slot. After an even number, the yellow corner is back in the slot, turned one third of the way round.

4. The rule

Yellow down, a twisted corner at the bottom front right. Then:

  1. Yellow sticker faces right: run R U R' U' twice.
  2. Yellow sticker faces you: run it four times.
  3. Yellow is now on the bottom. Turn D until the next twisted corner is at the bottom front right, and repeat.
  4. When every yellow sticker is on the bottom, turn D until the bottom layer lines up with the centres. The cube is solved.

Two runs move the yellow sticker from the right to the floor. Two more move it from the front to the right. So “front” is just the case that is two runs further away. If you lose count, keep going in pairs until yellow is on the bottom. That always works.

Turn D, never y. This is the reverse of Lesson 8, where you had to rotate the whole cube with y. Here, y carries the half-finished mess in the white layers away with it, and the cube does not come back. Measured: following the rule with y in place of D failed in 1,895 of 2,000 positions. J Perm says the same: “turn the bottom layer (not the whole cube)”.1

5. The cube will look destroyed. Keep going.

After your first corner, the white layers on top will be scrambled. In every one of 2,840 measured positions they were broken at that point. Beginners stop here and think they have ruined the solve. They have not.

The rule is: never stop halfway, and never change the hold. The mess is undone by the runs you make on the remaining corners.

Here is why it comes back. A corner can only twist in thirds, and the law of the cube is that the twists of all eight corners add up to a whole number of full turns. No move can change that.3 That law is why you never see exactly one twisted corner. It also means your runs always add up to 6 or 12. Lesson 4 showed that six runs of R U R' U' bring any cube back to where it started. So the white layers have to come back when the last corner is done.

Measured over 20,000 random positions: every one ended solved. 5% needed no runs, 59% needed 6, and 36% needed 12. No other totals came up.

6. Twice, four times, or turn D?

Six rounds. Yellow is down and the bottom-front-right corner is marked. Some rounds start mid-step, with the white layers already messed up. That is normal. Answering applies your choice so you can see where the yellow sticker went.

Retrieval — 6 rounds

7. Practise the whole step

Everything is placed and some corners are twisted. Finish the cube. The counter shows how many yellow stickers are on the bottom. You choose the moves.

 

 

 

Before the next lesson

  • Three full solves. Scramble, then all seven steps, without the cards. This is the first time you can finish one.
  • Say the hold change out loud when you flip the cube: “yellow down, turn D, never y.”
  • Read: J Perm’s beginner tutorial, the last step only. It is the same method in a few lines, and a good check that you are doing it the way most cubers do.
  • Keep: the Last Corners card. After a gap, read that, not this.
  • The cube stays out. Still the instruction that matters most.

Sources

  1. J Perm, How to Solve the 3x3: the last step, the repeated four-move sequence, and “turn the bottom layer (not the whole cube)”.
  2. Speedsolving wiki, Sexy Move: the community name for R U R' U'.
  3. Jaap Scherphuis, Useful Mathematics: the corner twist law, and why a single twisted corner cannot happen.

Quiz

Score: 0 / 0 · 0 of 5 answered

Answer from memory, then check.

  1. How do you hold the cube for this step?

  2. The yellow sticker faces right. How many runs of the opener?

  3. The next twisted corner needs to come to the bottom front right. How do you bring it there?

  4. After your first corner, the white layers look scrambled. What should you do?

  5. How many corners can be twisted at the start of this step?

Next: no new material. A full solve with the reference cards closed, which is the real test.

Your answers are saved only in this browser, so you can pick up where you left off.